Allied Telesis AT-S97 - Manual (Page 85)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
85
This command disables Auto-Negotiation of the twisted pair port in
channel 2 of a media converter module and sets the port’s speed and
duplex mode to 10 Mbps, full-duplex, and the MDI/MDI-X setting to MDI.
The module is in slot 1 of a chassis with the ID number 0:
system set port id=0/1/2/a auto-neg=disable speed=10
duplex=full crossover=mdi
This command activates Auto-Negotiation on the twisted pair port in
channel 4. The module is in slot 1:
system set port id=0/1/4/a auto-neg=enable
This command sets the duplex mode to half-duplex for the fiber optic port
in channel 11 on a module in slot 2:
system set port id=0/2/11/b duplex=half
This command disables the fiber optic port in channel 6 of the module in
slot 1. The chassis has the ID number 31:
system set port id=31/1/6/b port-state=disable
The previous examples illustrate how to configure a single port on a media
converter module. By omitting the CHANNEL parameter, you can
configure all of the ports of the same type (i.e., twisted pair or fiber optic)
with just one command. This is illustrated in the following two examples.
This command disables all the twisted pair ports in the media converter
module in slot 1. The chassis has the ID number 0:
system set port id=0/1/a port-state=disable
This command sets the duplex mode to half-duplex for all the fiber optic
ports in the media converter module in slot 2. The chassis has the ID
number 0:
system set port id=0/2/a duplex=half
The SYSTEM SET PORT command can also be used to configure the 10/
100/1000Base-T Management port on the management module. This
example disables Auto-Negotiation on the port and sets it to 100 Mbps,
full-duplex. The chassis has the ID number 0:
system set port id=0/m auto-neg=disable speed=100
duplex=full
system set port id=0/2/5/a auto-neg=disable speed=100 duplex=half
Chassis
Slot Channel
Port