Allied Telesis AT-S97 - Manual (Page 138)

Chapter 8: Configuration File Commands
138
Converter Modules represents twisted pair port 1 and fiber optic port 1,
PORTID=2 designates channel 2 of twisted pair port 2 and fiber optic port
2, and so on.
Figure 28. Blade Configuration - Operating Mode Section
Note the following guidelines when modifying the commands in this
section:
ˆ Each channel must have its own command line.
ˆ If you delete a command, the corresponding channel’s operating mode
will be Link Test, the default value.
ˆ As previously mentioned, the PORTID parameter must specify just the
channel number. Do not include a chassis ID or slot number. The latter
are defined in the header lines of the Blade Configuration section.
The next subsection in a Blade Configuration, shown in Figure 29,
configures the operating parameters of the ports on the media converter
module, both twisted pair and fiber optic. The port operating parameters
are set with a modified version of the SYSTEM SET PORT command,
where the values in the ID parameter are truncated to the channel number
and port letter. For a description of this command, refer to “SYSTEM SET
PORT” on page 80.
Figure 29. Blade Configuration - Port Operating Parameters
### Blade Configuration
system set interface portId=1 OpMode=link-test
system set interface portId=2 OpMode=link-test
system set interface portId=3 OpMode=link-test
system set interface portId=4 OpMode=link-test
system set interface portId=5 OpMode=link-test
system set port id=1/a ingress-rate-limit=none egress-rate-limit=none
system set port id=1/b duplex=full ingress-rate-limit=none egress-rate-
limit=none
system set port id=2/a speed=100 duplex=full crossover=mdi
system set port id=2/a ingress-rate-limit=128k egress-rate-limit=none
system set port id=2/b duplex=full ingress-rate-limit=none egress-rate-
limit=none
system set port id=3/a ingress-rate-limit=none egress-rate-limit=none
system set port id=3/b duplex=full ingress-rate-limit=none egress-rate-
limit=none
system set port id=4/a speed=10 duplex=full crossover=mdi
system set port id=4/a ingress-rate-limit=none egress-rate-limit=none
system set port id=4/b duplex=full ingress-rate-limit=none egress-rate-
limit=none