Allied Telesis AT-S97 - Manual (Page 82)

Chapter 5: Port and Module Commands
82
duplex Sets the duplex mode of a port. Available settings are:
full Sets the duplex mode of the port to full-duplex.
This is the default setting for a fiber optic port
that does not support Auto-Negotiation.
half Sets the duplex mode of the port to half-duplex.
crossover Sets the wiring configuration of a twisted pair port. Auto-
Negotiation must be disabled on the port to set this
parameter. Available settings are:
mdi Sets the wiring configuration to MDI.
mdix Sets the wiring configuration to MDI-X.
ingress-rate-limit
Defines the maximum number of bits per second a port
accepts from the network device connected to it.
egress-rate-limit
Defines the maximum number of bits per second a port will
transmit to the network device connected to it.
Privilege Levels
Administrator and read-write.
Description
This command configures the following parameter settings on a port in a
media converter channel:
ˆ Port status
ˆ Auto-Negotiation
ˆ Speed and duplex mode
ˆ MDI/MDI-X wiring configuration
ˆ Ingress and egress filtering
This command can also set the operating parameters of the 10/100/
1000Base-T Management port on the management module. To view the
current settings of a port, refer to “SYSTEM SHOW INTERFACE” on
page 90.