Allied Telesis AT-S97 - Manual (Page 60)

Chapter 4: General System Commands
60
SYSTEM SHOW INFO
Syntax
system show info
Parameters
None.
Privilege Levels
Administrator, read-write, and read-only.
Description
This command displays the stack’s name, the name of the network
administrator responsible for managing the units, and the location of the
stack, as shown in Figure 7.
Figure 7. SYSTEM SHOW INFO Command
To configure these parameters, refer to:
ˆ “SYSTEM SET HOSTNAME” on page 55
ˆ “SYSTEM SET CONTACT” on page 54
ˆ “SYSTEM SET LOCATION” on page 56.
Note
Although version 1.3.0 does not support stacking, you can still
configure this information.
Example
system show info
System Information
Hostname ............ Engineering MCF
Contact ............. Jane Smith
Location ............ Bldg 3, Fl 1, Closet 122