Allied Telesis AT-S97 - Manual (Page 39)

39
Chapter 3
IP Configuration Commands
This chapter contains the following sections:
ˆ “Overview” on page 40
ˆ “IP DHCP DISABLE” on page 42
ˆ “IP DHCP ENABLE” on page 43
ˆ “IP SET” on page 44
ˆ “IP SHOW” on page 46
Note
Remember to save your parameters changes in the active master
configuration file with the CONFIG SAVE command. For information,
refer to “Saving Your Configuration Changes” on page 17 or Chapter
8, “Configuration File Commands” on page 129.