Allied Telesis AT-S97 - Manual (Page 27)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
27
What to Configure First
This section has a few suggestions on what to configure when you are
managing the chassis for the first time. The initial management session
must be a local session. For instructions on how to start a local
management session, refer to “Starting a Local Management Session” on
page 20.
Note
Although the management module comes with the default IP
address 10.0.0.1 and subnet mask 255.255.252.0, the initial
configuration of the chassis cannot be a remote session because the
module’s Telnet and SSH servers are initially disabled.
Displaying the
Chassis Modules
After logging on, enter this command:
system show cluster
The command displays the management and media converter modules in
the chassis. You can use this information to verify the modules in the unit.
An example is shown in Figure 4.
Figure 4. Displaying the Chassis Modules with the SYSTEM SHOW
CLUSTER Command
For information on this command, refer to “SYSTEM SHOW CLUSTER”
on page 88.
Chassis Chassis Chassis MAC Master
ID Name Type Address Chassis
------------------------------------------------------------------
0 AT-MCF2000 11:22:33:44:55:55 Yes
Slot ID Module Name Module Type Software Version
------------------------------------------------------------
M
AT-MCF2000M v1.3.0
1 AT-MCF2012LC v1.3.0
2 AT-MCF2012LC v1.3.0
Chassis information
Management and media converter module information