Allied Telesis AT-S97 - Manual (Page 50)

Chapter 4: General System Commands
50
SYSTEM SET ASYNCHRONOUS
Syntax
system set asynchronous baudrate=2400|4800|9600|19200|115200
Parameters
baudrate Sets the baud rate of the RS-232 Terminal port on the
AT-MCF2000M Management Module. The default is
115200 bits per second (bps).
Privilege Levels
Administrator and read-write.
Description
This command sets the baud rate of the RS-232 Terminal port on the
AT-MCF2000M Management Module. This port is used for local
management of the chassis. To view the port’s current baud rate setting,
refer to “SYSTEM SHOW ASYNCHRONOUS” on page 57.
Note
Changing the baud rate of the RS-232 Terminal port on the
management module during a local management session ends the
session. To resume managing the module, you must change the
speed of the terminal or the terminal emulator program to the new
speed of the RS-232 Terminal port.
The other settings of the RS-232 Terminal port listed here are not
adjustable:
ˆ Data bits: 8
ˆ Parity: None
ˆ Stop bits: 1
ˆ Flow control: None
Example
This command sets the baud rate of the RS-232 Terminal port to 2400
bps:
system set asynchronous baudrate=2400