Allied Telesis AT-S97 - Manual (Page 44)

Chapter 3: IP Configuration Commands
44
IP SET
Syntax
ip set ip-address= ipaddress subnetmask= mask
default-gateway= ipaddress
Parameters
ip-address Specifies an IP address for the AT-MCF2000M
Management Module. The default value is 10.0.0.1.
subnetmask Specifies a subnet mask for the management module’s IP
address. The mask can be of variable length. The default
value is 255.255.252.0.
default-gateway
Specifies a default gateway for the management module.
The default gateway must be a member of the same subnet
as the module’s IP address. The default value is 0.0.0.0.
Privilege Levels
Administrator and read-write.
Description
This command manually assigns an IP address, subnet mask, and default
gateway address to the AT-MCF2000M Management Module. For
information on when to assign an IP configuration to the module, refer to
“Overview” on page 40.
Note
You cannot assign an IP configuration to the management module if
the DHCP and BOOTP clients are active. You must first disable the
clients with the IP DHCP DISABLE command. For information, refer
to “IP DHCP DISABLE” on page 42. To determine the status of the
clients, refer to “IP SHOW” on page 46.
Examples
This command assigns the IP address 149.22.67.8, subnet mask
255.255.255.224, and default gateway 149.22.67.247 to the
AT-MCF2000M Management Module:
ip set ip-address=149.22.67.8 subnetmask=255.255.255.224
default-gateway=149.22.67.247