beautypg.com

NORD Drivesystems BU0300 User Manual

Page 54

background image

NORDAC trio SK 300E Manual

54

Subject to technical alterations

BU 0300 EN

4.3

ParameterBox (Installation variant)

(SK PAR-2E, Part. No. 278910110)

The SK PAR-2E ParameterBox is a compact control device for control panel
installation. Up to 5 frequency inverters can be connected via the plug-in
connection terminals. Protection class IP66 is complied with on the front side
when installed.
A connection cable for the ParameterBox is not included in the scope of
delivery. A commercial 4-wire cable with a recommended cable cross-section
of 0.75mm

2

can be used in compliance with the general installation

regulations.
The 15V supply voltage for the ParameterBox is normally drawn from the
frequency inverter.

Mechanical installation in a control panel

For installation in the control cabinet door or the control panel, a cut-out of 137mm x 82mm (tolerance +/- 1mm)
must be made. The sealed unit must be inserted in the pre-processed cabinet panel. There are 6 screws (M3 x
7mm) for securing the unit to the interior of the control panel. The ParameterBox is now mounted securely on
the switching cabinet door and has maximum protection class IP66 on the front side, if mounted correctly.

The electrical connection of the ParameterBox SK PAR-2E can take place in the installation variant via the
internal screw terminals 1-4. Exact assignment of the terminals can be seen in the following section.


Seal

Seal

137 mm

82 mm

136 mm

162 mm

35 mm

80 mm

35 mm

100 mm

73 mm

146 mm

90 mm

+/-1mm

+/-1mm

Fastening screws

6 x M3 x 7mm

(nuts and washers are included)

Control cabinet front
Æ

Control cabinet interior

Е