Documentation, Version list, Published by – NORD Drivesystems BU0300 User Manual
Page 3: Getriebebau nord gmbh & co. kg, Intended use of the frequency inverter
NORDAC trio SK 300E Manual
Concerning this document
BU 0300 EN
3
Documentation
Designation: BU 0300 EN
Part. No.: 607 30 01
Device series: NORDAC trio SK 300E
Version list
Designation of previous issues
SW status
Comments
BU 0300 DE, August 2005
V 1.6 R0
First issue
BU 0300 DE, December 2005
V 1.8 R0
3~230V implemented, plug-in design
BU 0300 DE, March 2006
Part. No. 607 3001 / 1306
V 1.8 R2
Wall mounting kit, technology units upgraded,
parameters supplemented, Harting connector, ATEX
Zone 22, Differentiation between IP55 and IP66 design
BU 0300 DE, June 2007
Part. No. 607 3001 / 2307
V 1.8 R2
Technical data of relay function changed, 5V max.
275mA, analogue setpoint input resistance, new SK
PAR-2H / -2E version, UL data
BU 0300 DE, January 2008
Part. No. 607 3001 / 1208
V 1.9 R0
Incorporation of 1~230V operation, new braking
resistors, UL data updated, P551 corrected
Published by
Getriebebau NORD GmbH & Co. KG
Rudolf- Diesel- Str. 1
• D-22941 Bargteheide • Germany • http://www.nord.com/
Telephone +49 (0) 45 32 / 401-0
• Fax +49 (0) 45 32 / 401-555
Intended use
of the frequency inverter
Compliance
with the operating instructions is the requirement for error-free operation and
the fulfilment of any warranty claims. You must first read these operating instructions before
working with the device!
These operating instructions contain important information about service and safety. They
must therefore be kept close to the device.
The trio SK 300E frequency inverters are devices for industrial and commercial plants for
operating three-phase asynchronous motors with squirrel-cage rotors. These motors must be
suitable for operation with frequency inverters, other loads must not be connected to the
devices.
The trio SK 300E frequency inverters are devices for stationary installation on machines. All
details regarding technical data and permissible conditions at the installation site must be
complied with.
Commissioning (implementation of the intended use) is not permitted until it has been ensured
that the machine complies with the EMC directive 89/336/EEC and that the conformity of the
end product meets the machine directive 89/392/EEC (note EN 60204).
© Getriebebau NORD GmbH & Co. KG, 2007