NORD Drivesystems BU0300 - Manual (Page 13)

2 Assembly and installation
BU 0300 EN Subject to technical alterations 13
2.2 Wall mounting kit
(SK WMK-DA1, Part. No. 275115100)
The geared motor and inverter can be installed
separately, using the wall mounting kit, so that
the SK 300E can be used close to the motor.
With this option the frequency inverter can be
mounted directly on a wall or machine scaffold
with a very high protection class of IP55 / IP66.
Installation
The wall mounting kit must be fitted using the
hole pattern below.
Commissioning
43 mm
160 mm
125 mm
157,5 mm 128 mm
The wall-mounting kit (SK WMK-DA1) is a
modular design system, i.e. an adapter unit
must be selected first (SK TI 0/1 or SK TI 0/2)
so that the SK 300E frequency inverter can be
fitted to the wall-mounting kit.
When delivered, the wall-mounting kit with the
SK 300E is ready for connection to mains,
motor and control cables. The frequency
inverter only needs to be pushed on after the
cables are connected.
Different datasets from the frequency inverter
and "electronic name plate" will be displayed in
the operating display (E8.6) and by the red
LED during initial commissioning only. This
display serves to inform the operator; the
message is acknowledged by an Enable signal
and the datasets are then synchronised. After
the factory settings are loaded (P523) and the
motor data are set, the frequency inverter is
ready to be switched on.
Fastening holes in detail:
12 m
m
5,
5 mm
Module contents
Note
Data for power derating in the close to motor version at high ambient temperatures can be found in
Chap. 9.1 General Data.