NORD Drivesystems BU0300 - Manual (Page 40)

NORDAC trio SK 300E Manual
40 Subject to technical alterations BU 0300 EN
Menu structure with the ControlBox
P0 0 1
_ _ _ _
P10 0 P2 0 0 P5 0 3 P70 0
P0 0 3 P10 1
P10 2
P113
P2 0 1
P2 0 2
P2 16
P5 0 4
P5 0 5
P5 5 9
Operating va lues display
(or operational)
following mains ON
P4 0 0
P4 0 1
P4 0 2
P4 8 3
P70 1
P70 7
P9 9 9
To change a parameter value, the ENTER key must be pressed when the applicable parameter number
is displayed.
Changes can then be made using the VALUE keys or and must be confirmed with to save them
and leave the parameter.
As long as a changed value has not been confirmed by pressing ENTER, the value display will blink; this value
has not yet been stored in the frequency inverter.
During parameter changes, the display does not blink so that the display is more legible.
If a change is not to be saved, the "DIRECTION" key can be pressed to leave the parameter.
Accept changed value
Simultaneous pressing:
Value to factory setting
Increase value Reduce value
Do not accept
changed value
(direction key))
Parameter set display