beautypg.com

NORD Drivesystems BU0300 User Manual

Page 39

background image

3.2 Technology unit overview

BU 0300 EN

Subject to technical alterations

39

Parameterisation with the ControlBox

The parameterisation of the frequency inverter can take place in the various operating states. All parameters
can always be changed online. Switching to the parameter mode occurs in different ways depending upon the
operating states and the enabling source.

1.

If there is no enable (if necessary, press the STOP key

) via the ControlBox, control terminals or a

serial interface, it is still possible to switch to the parameterisation mode directly from the operating
value display with the value keys

or

. Æ

P 0 0 1 ... P 9 9 9

2.

If an enable is present via the control terminals or a serial interface and the frequency inverter is
producing an output frequency, it is also possible to switch to the parameterisation mode directly from
the operating value display using the value keys

or

. Æ

P 0 0 1 / P 9 9 9

3.

If the frequency inverter is enabled via the ControlBox (START key

), the parameterisation mode

can be reached by pressing the START and ENTER keys (

+

) simultaneously.

4.

Switching back to the control mode is achieved by pressing the START key

.

Simultaneous pressing:

Switching from control to

parameterisation while the

drive is running

(see Point 3)

Select menu group,

display parameter value

(Enter key)

One level each time back to

the operating value display

Next menu group or

parameter number

Previous menu group or

parameter number

Switching from

parameterisation to control

(see Point 3)

Parameter set display

Changing parameter values

To access the parameter section, one of the value keys

or

must be pressed. The display changes to

the parameter display

P 0 0 1 ... P 9 9 9. All parameters are arranged in order in a continuous scroll pattern.

It is therefore possible to scroll forwards and backwards within this section.
Each parameter has a parameter number Æ

P x x x . The significance and description of the parameters

starts in Chapter 7 "Parameterisation"

When the required parameter has been selected, press the ENTER key

to display the parameter value and

change the value with the value keys

or

. A flashing display indicates that the value has been changed

but not yet stored. Pressing the ENTER key

stores the changed value.