Triton X-SCALE/X2 Configuration Manual - Manual (Page 57)

4 7
D
IAGNOSTICS
C
ONFIGURE
M
ODEM
/ T
RITON
C
ONNECT
S
ETTINGS
A CCESS I NSTRUCTIONS :
1. From the D
IAGNOSTICS
screen, select the M
ODEM
/E
THERNET
option by pressing <7> on the keypad.
2. From the M ODEM /E THERNET screen, select the C ONFIGURE M ODEM option by pressing <4> on the
keypad.
3. From the M ODEM /E THERNET screen, select the T RITON C ONNECT S ETTINGS option by pressing <5> on
the keypad.
Press the LEAR > key until the parameter that will be configured is highlighted.
If the parameter is enabled (checked), highlight the parameter and press the key to place or
remove a check from the box. If the parameter is selected from a list of choices, use the LEAR > key to
highlight the parameter and the Right (>) and Left (<) arrow keys to display the desired parameter.
P ORT S ETTINGS
***WARNING***
Do not attempt to alter any of the following parameters unless you are abso-
lutely certain of the result. If incorrectly set, some of these parameters can cause
communication failure.
D ESCRIPTION :
The C
ONFIGURE
M
ODEM
and T
RITON
C
ONNECT
S
ETTINGS
functions allow changing the modem parameters.
Pressing the applicable key (<4> for Configure Modem or <5> for Triton Connect Settings) will display the
Select Modem dialog. The name of the modem that will be configured is shown in the dialog.
Press the LEAR > key on the keypad until the “C ONFIGURE ” button is highlighted. Press the NTER >
key. The device properties screen is now displayed.