Display mac address in management functions, Journal archive changes, Corrupt file recovery – Triton X-SCALE/X2 Configuration Manual User Manual
Page 314: Rear service panel day close changes, Rear service panel communication changes, T callback, Riton, Onnect unless connection first established, Nvalid, Lose would still print host totals

Don’t callback Triton Connect unless connection first established
In previous software releases for XScale terminals, if a terminal is configured for dialup for
Triton Connect and an incoming call occurs but does not fully negotiate with the terminal, the
terminal would call back to Triton Connect to complete the call. This could cause call collisions
with Triton Connect.
This behavior has changed so the terminal will not call Triton Connect unless the modem
negotiation completes, and instead the terminal will disconnect and wait for the call again.
Invalid CRC on Day Close would still print host totals
When the terminal initiates a Day Close or Trial Day Close and the message response CRC fails,
the terminal would still display the totals sent by the host, which may not be valid. This software
release corrects this and will not display the totals. A message “Host Totals Not Received” will
be displayed for this condition.
Display MAC address in Management Functions
The terminal will now display the MAC address in Management Functions => Terminal Status
=> Configuration Summary.
Journal archive changes
The journal archive process (either through Auto Archive or Manual Archive) will now delete all
journal records prior to the last audited record within the specified date range.
Corrupt file recovery
This release contains some changes to attempt to recover from a corrupt file on flash that might
have previously caused the system to hang during boot.
Rear service panel Day Close changes
This release fixes an issue where text would wrap on the Day Close report print out of an
RT2000 or FT5000 terminal.
Restore Parameters from External Storage warning box
This release fixes an issue where the warning message on the Restore Parameters From External
Storage was cut off.
Rear service panel communication changes
This release fixes an issue where the rear service panel would not respond to the terminal.
Software Release Notes
Triton Systems
Page 10 of 30
July 26, 2007