Triton X-SCALE/X2 Configuration Manual - Manual (Page 128)

118
X-S
CALE
/ X2 C
ONFIGURATION
M
ANUAL
ISO / S
URCHARGE
P
ROPERTIES
A
CCESS
I
NSTRUCTIONS
:
1. From the T
ERMINAL
C
ONFIGURATION
screen, select the ISO / S
URCHARGE
P
ROPERTIES
option by press-
ing <5> on the keypad.
D
ESCRIPTION
:
The ISO/S
URCHARGE
P
ROPERTIES
option allows the terminal operator to perform the following functions:
S
URCHARGE
A
MOUNT
C
ONFIGURATION
1. E
NABLE
/ D
ISABLE
S
URCHARGE
. Some networks allow a surcharge (or terminal fee) to be imposed on
transactions. If surcharges are in use on your network, you are required to notify the customer of
any additional fee before the transaction is processed. Enabling (checked) surcharge will initiate a
surcharge notification message to be displayed prior to final processing of the transaction. The
customer then has the option of cancelling the transaction or continuing.
Note: If your processor requires a surcharge, you MUST enable (checked) this option.
! Press <1> to toggle between enable (check) or disable (unchecked).
2. A
MOUNT
. This option is the fixed-value surcharge amount that will be displayed to the customer in
the surcharge notification message. The surcharge amount that you enter will be displayed to the
customer and must match the actual surcharge rate established by your processor or other applicable
regulatory agencies!
Manually changing the surcharge amount to a higher (or lower) amount does not change the surcharge
collected by the processor. It only changes the surcharge amount displayed to the customer and not
the actual fee collected.