Triton FT7000 POWER CORD Installation Manual - Manual

P
OWER
C
ORD
I
NSTALLATION
G
UIDE
(RL2000, FT5000 XP , FT7000)
NOTE
The Power Cord interface cable is located inside the vault area (Dispenser location) of the cabinet.
To gain access and connect the power cord included in the accessory box, you may have to remove
the dispenser. Refer to your applicable Installation or Service manual for removal procedures of
your dispenser.
1. Obtain the power cord that is located in the accessory box. From the exterior of cabinet, feed the small end
of the cable through the closest cable access hole (lower part of cabinet).
2. Connect and route the power cord in the unit as shown in figures below.
TDN 07100-00084 Rev C
3. Reinstall the dispenser, if applicable.
FT5000 XP
RL2000
FT7000