Using the data protector gui – HP B6960-90078 User Manual
Page 699
ADIC/GRAU DAS and STK ACS Libraries
The ADIC/GRAU DAS Library Device
Chapter 14
669
2. Open the
EIF-Configuration
window by double-clicking the
I/O unit icon, and then click the
Logical Ranges
field.
In the text box the available
Insert/Eject
Areas are listed.
NOTE
One Data Protector library device can handle only one media type.
It is important to remember which media type belongs to each one of the
specified Insert and Eject Areas, because you will need this data later for
configuring Insert/Eject Areas for the Data Protector library.
Run the following system command to check whether or not the library
drives are properly connected to your system:
lsdev -C
You should see your device listed.
Remote
Installation
The installation procedure consists of these steps:
1. Distribute the DAS Agent component to clients using the Data
Protector graphical user interface and Installation Server.
2. Physically connect the library drives and robotics to the systems
where you have installed the DAS Agent software.
See for
details about supported ADIC/GRAU libraries.
At this stage, you should have your hardware connected and your DAS
software properly installed.
For the AIX platform, install the ADIC/GRAU library for client interface:
Copy
libaci.o
shared library into the
directory.
Using the Data Protector GUI
Configure the ADIC/GRAU library the DAS client of which will access
ADIC/GRAU robotics during specific Media Management operations
(Query, Enter, Eject). The steps are as follows:
• In the
HP OpenView Storage Data Protector Manager
switch to
the
Devices & Media
context. In the Scoping Pane, right-click
Devices
and then click
Add Device
.