HP B6960-90078 - Manual (Page 583)

Troubleshooting
Debugging
Chapter 12 553
Debugging
You should collect debugs only when the support organization requires
them to resolve a technical issue. When Data Protector runs in debug
mode, it creates debug information that consumes a large amount of disk
space. Consult the support organization about the detail level that
should be applied and environmental conditions for running Data
Protector in the debug mode.
Limiting the Maximum Size of Debugs
Circular
Debugging Data Protector can run in a special debugging mode called circular
debugging. In this mode, debugging messages are added until the size of
the debug file reaches a preset size (
n ). The counter is then reset and the
oldest debugging messages are overwritten. This limits the trace file
size, but does not affect the latest records.
When to Use
Circular
Debugging Using this mode is recommended only if the problem occurs near the end
of the session or if Data Protector aborts or finishes soon after the
problem has occurred.
Estimating the
Required Disk
Space With circular debugging turned on, an estimate of the maximum
required disk space is as follows:
• On Media Agent client(s): 2*n [kB] for each running MA in a backup
or restore.
• On Disk Agent client(s): 2*n [kB] for each mount point in a backup
or restore.
• On the Cell Manager client: 2*n [kB] .
• On a integration client: 2*n [kB] * parallelism .
• For Inet and CRS debugging, the upper limit cannot be reliably
determined, because separate debug traces are produced for various
actions.