Rds does not work on the windows tse cell manager, Problems starting data protector daemons on unix – HP B6960-90078 User Manual
Page 601
Troubleshooting
Troubleshooting Data Protector Services and Daemons
Chapter 12
571
directory and the problems should be resolved.
2. Restart the services using the
omnisv -start
command.
RDS does not work on the Windows TSE Cell Manager
Use TCP transport instead of local transport by modifying the
file:
Under
TCP Configuration
, set
Enabled
to
yes
.
Problems Starting Data Protector Daemons on UNIX
The following daemons run on the UNIX Cell Manager:
• Data Protector CRS daemon:
/opt/omni/lbin/crs
• IDB daemon:
/opt/omni/lbin/rds
• Data Protector Media Management daemon:
/opt/omni/lbin/mmd
The
Data Protector Inet
service
(/opt/omni/lbin/inet)
is started
by the system inet daemon when an application tries to connect to the
Data Protector port, which is by default port number 5555.
Normally, these daemons are started automatically during the system’s
start-up.
To manually stop, start, and get the status of Data Protector daemons,
log on to the Cell Manager as root.
Stopping
Daemons
To stop the Data Protector daemons, enter the following command in the
/opt/omni/sbin
directory:
omnisv -stop
Starting Daemons
To start the Data Protector daemons, enter the following command in the
/opt/omni/sbin
directory:
omnisv -start
Checking the
Status of the
Daemons
To check the running status of the Data Protector daemons, enter the
following command in the
/opt/omni/sbin
directory:
omnisv -status