HP B6960-90078 - Manual (Page 477)

Disaster Recovery
Preparing for a Disaster Recovery
Chapter 10 447
Omnisrdupdate requires a session_ID to update an existing SRD file
with backup object information belonging to the given session. Using this
value,
omnisrdupdate will update the SRD file with the backup object
information which belongs to the passed session_ID value. After the
SRD is updated it will be saved back on the Cell Manager.
This procedure will only succeed if all critical backup objects (as specified
in the SRD file) were actually backed up during the specified session. To
view which objects are considered as critical for the SRD update, open
the SRD file in a text editor and find the objects section. All critical
objects for the SRD update are listed there. Note that the database is
represented as “/”.
Here is an example of an objects section of the SRD file:
-section objects
-objcount 3
-object /C -objtype 6 -objpurpose 283
-endobject /C
-object / -objtype 3 -objpurpose 32
-endobject /
-object /CONFIGURATION -objtype 6 -objpurpose 4
-endobject /CONFIGURATION
-endsection objects
In this case, there are 3 critical objects: /C , / (database) and
/ CONFIGURATION .
TIP To obtain the session ID, execute the omnidb command with the option
-session . To obtain the latest session ID, at the command prompt type
omnidb -session -latest .
The updated SRD file should be kept in a safe place so that it is not lost
in the case of disaster. To locate where the updated SRD file will be
saved, use the
-location option with the omnisrdupdate command.
There can be more than one -location parameters specified (including
network shares on which you have write permission), each of which will
receive an updated copy of the SRD file. See “Preparation” on page 451.