8 jump 64, Jump 64 – Avago Technologies LSI53C1010 User Manual
Page 72
3-32
The SCSI SCRIPTS Processor Instruction Set
JUMP REL(address),
IF CARRY
JUMP REL(address),
IF data
JUMP REL(address),
IF data AND MASK data
JUMP REL(address),
IF ATN AND data
JUMP REL(address),
IF ATN AND data
AND
MASK data
JUMP REL(address),
IF Phase AND data
JUMP REL(address),
IF Phase AND data AND
MASK
data
JUMP REL(address),
WHEN
Phase
JUMP REL(address),
WHEN
CARRY
JUMP REL(address),
WHEN
data
JUMP REL(address),
WHEN
data AND MASK data
JUMP REL(address),
WHEN
Phase AND data
JUMP REL(address),
WHEN
Phase AND data AND
MASK
data
JUMP REL(address),
IF NOT ATN
JUMP REL(address),
IF NOT Phase
JUMP REL(address),
IF NOT CARRY
JUMP REL(address),
IF NOT data
JUMP REL(address),
IF NOT data AND
MASK
data
JUMP REL(address),
IF NOT ATN OR
data
JUMP REL(address),
IF NOT ATN OR
data
AND MASK data
JUMP REL(address),
IF NOT Phase OR
data
JUMP REL(address),
IF NOT Phase OR
data
AND MASK data
JUMP REL(address),
WHEN
NOT Phase
JUMP REL(address),
WHEN
NOT CARRY
JUMP REL(address),
WHEN
NOT data
JUMP REL(address),
WHEN
NOT data AND MASK
data
JUMP REL(address),
WHEN
NOT Phase OR data
JUMP REL(address),
WHEN
NOT Phase OR data
AND
MASK data
3.2.8 JUMP 64
This command is only available on LSI53C896 and newer chips.
JUMP64 {Address} [,{IF | WHEN}[NOT][ATN | Phase] AND | OR]
[data[AND MASK data]]]
JUMP64 {Address} [, {IF | WHEN}[NOT] CARRY]
Supported by
LSI53C896 and later chips.
Definition
SCSI Transfer Control - Jump.
Operands
This command has the following operands: