Avago Technologies LSI53C1010 - Manual (Page 281)

SCSI SCRIPTS Processors A-1
Appendix A
NASM Error Messages
Table A.1 NASM Error Messages
Error Description
24-bit value expected The value specified is not within the range of a 24-bit unsigned
integer. The value must be between 0 and 4 Mbytes.
Something other than a value was found.
8-bit value expected The value specified is not within the range of an 8-bit unsigned
integer. The value must be between 0 and 255.
Something other than a value was found.
ACK, ATN, TARGET or CARRY
expected string String was found instead of ACK, ATN, TARGET or CARRY.
AND or OR expected string String was found instead of AND or OR.
ATN specified multiple times The ATN field may only be specified once per instruction.
Cannot compare CARRY and
Data The command is requesting that both a comparison of the SFBR
register to the specified data and a test of the carry bit take place,
but only one test is allowed.
Cannot compare PHASE and
Data The command is requesting that both a comparison of the SCSI
bus phase and a comparison of the SFBR register to the
specified data take place, but only one test is allowed.
Cannot specify PHASE when
using ATN The use of PHASE and ATN are mutually exclusive.
Cannot use MASK without
compare Data Valid Data must be present when using the MASK field.
Cannot use Pass for count
address The PASS feature cannot be used in a count field. The current
format of the output file does not support this.
Carry operations not available on
LSI53C700 architectures The Carry feature is only available on the LSI53C710 or higher
architectures.
CARRY specified multiple times CARRY may only be specified once per instruction.