Avago Technologies LSI53C1010 User Manual
Page 283

A-3
ID specifier only valid for table entries
IF or WHEN expected string
String was found instead of one of IF or WHEN.
INTFLY: LSI53C720, LSI53C770,
and LSI53C8XX architecture only
The INTFLY instruction is only available on the LSI53C720 and
higher architectures.
Invalid Address string
String was found instead of a valid address. A valid address is
an expression, external, relative, table, or an absolute.
Invalid assignment
Invalid character/s
Invalid constant type
Invalid destination address string
String was found instead of a valid destination address. A valid
destination address is an expression, external, relative, table or
an absolute.
Invalid register operator string
String was found instead of a valid operator. Valid operators are
'+', '
−
', '|', '&'.
Invalid register value
Value must be in the range 0x0–0x3F for the LSI53C700/710 and
0x0–0x5C for the LSI53C720.
Invalid SCSI id
Value must have only one bit set (bits [0:7]) for the
LSI53C700/710/810. Must be in the range of [0:15] for the
LSI53C720/820/825.
Invalid syntax string
String was found and not expected causing an unknown syntax
error.
Invalid test condition string
String was found instead of a valid test condition. The valid test
conditions are CARRY, a PHASE, an 8-bit value, or a MASK.
LCRC LSI53C710 architectures
only
The LCRC register is only available on the LSI53C710
architecture.
Left parenthesis expected string
String was found instead of a left parentheses.
LOAD: LSI53C810A,
LSI53C825A, LSI53C860,
LSI53C875, LSI53C876,
LSI53C885, and LSI53C895
architectures
The LOAD instruction is only supported by the LSI53C810A and
higher architectures.
LOAD: Count must not exceed
4 bytes
Four bytes is the maximum byte count to LOAD.
Table A.1
NASM Error Messages (Cont.)
Error
Description