TA Triumph-Adler DC 2023 - Manual (Page 79)

4-7
Section 4 Other Features of this Fax
3A180100A
3A1/FaxSystem(A)/MCE-Eng
/ 164
8. If necessary, enter the predetermined F-Code password.
* The password can be up to 20 digits in length and can include
any combination of the numerals 0 - 9 and the symbols “ ” and
“#”. You do not have to enter an F-Code password here if you
agree in advance with the transmitting party not to use one.
* If you DO NOT need to enter an F-Code password, proceed to
step 9.
9. Press the Enter key.
* If the fax number you entered has already been registered for
this operation or too many numbers were entered, an error
message will appear in the message display. In this case, press
the Enter key and the message display will return to a display
that allows you to enter the transmitting party’s fax number again.
10. Select whether or not you want to continue entering other
transmitting fax numbers.
> If you DO want to enter more fax numbers, return to step 4 on
page 4-6.
> If you are finished entering fax numbers, proceed to step 11.
11. If you want to designate a time for the reception to begin,
press the DELAYED TX. key.
* If the maximum allowable number of communications that use
the timer (max: 50) is reached, an error message will appear in
the message display. In this case, press the Enter key and the
operation panel will return to the initial mode settings.
* If you want the reception to begin right away, this step is not
necessary. Proceed to step 14.
12. Press the Enter key.
v :
Enter destination
TX time:12:00
Enter transmission time
13. Use the keypad to enter the desired time for the reception to
begin.
* If you want to reset the displayed time to “00:00”, simply press
the Stop/Clear key.
14. Press the Enter key. The reception operation will begin
automatically.
* If a time for the reception to begin was designated, the reception
operation will begin when the appointed time is reached.
Password:
3856
20 digits
Enter your password
TX time:20:00
Enter transmission time
04/OtherF-1/3A1/MCE/Eng.q 23-12-1999 13:48 Page 4-7