TA Triumph-Adler DC 2023 - Manual (Page 50)

4. Press the Enter key.
5. Use the cursor up or the cursor down key to select whether or not
you want to include a cover page with the transmission.
> If you want to include a 1-sided page as a cover sheet, select
“Yes”. In this case, the fax will first transmit only the front side of
the first page of the documents PRIOR to transmitting
the 2-sided documents.
> If you only want to transmit the 2-sided documents, select “No”.
6. Press the Enter key.
7. Use the cursor up or the cursor down key to select whether or not
you want the data for the rear side of the documents to be inverted
to match the orientation of the front side during transmission.
> If you set the documents as shown in the illustration immediately
below, select “On”. The fax will then invert the image of the rear
side of each document in memory 180°.
> If you set the documents as shown in the illustration below,
select “Off”.
8. Press the Enter key. The documents will be scanned into memory
and the transmission operation will begin automatically.
2-2
Section 2 Various Functions of this Fax
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
1. Set the 2-sided documents in the SRDF.
2. Raise both cover plates and press the DUPLEX TX key.
* You can cancel a Duplex Transmission by simply pressing the
DUPLEX TX key again.
3. Enter the destination fax number.
* You can enter the fax number using the keypad, abbreviated
numbers, one-touch keys, program keys, group dial keys or the
directory. Chain dial keys can be used as well.
Duplex Transmission
Duplex Transmission enables the transmission of both the front
and back sides of duplex (2-sided) documents.
Duplex transmission is always accomplished by setting the
documents you want to transmit in the SRDF and scanning them
into memory in the Memory Transmission mode. It is also
possible to use Duplex Transmission capabilities in combination
with each of the other various types of fax communication
available in this fax. The following method explains the
procedure for sending duplex documents to a single destination. * To enable Duplex Transmission, you must select “Standard
size original” when setting the document size for scanning from
the Document Feeder. Duplex Transmission will not be
available if the document size is set to “Long original”.
(Refer to “Setting the Document Size for Scanning from the
Document Feeder”, page 6-7.)
* If you press the DUPLEX TX key during any operation,
Dial Confirmation for one-touch keys will not be available.
It will also be necessary to press the Start key in order to
initiate dialling for abbreviated numbers and one-touch keys.
* In order to schedule a start time for the transmission, press the
DELAYED TX. key at any point in the procedure PRIOR to
entering the destination fax number.
3A180100A
3A1/FaxSystem(A)/MCE-Eng
/ 164
Cover page:
Yes
➪ No
Top binding:
➪ On
Off
(Direction of document feed)
destination fax>
(Direction of document feed)
destination fax>
01-DEC-1999 12:00
Set original
01-DEC-1999 12:00
Document :A4
Enter destination
v :
Document :A4
Enter destination
v :35642
Document :A4
Enter destination
D
D
02/VariousF/3A1/MCE/Eng.q 23-12-1999 13:31 Page 2-2