TA Triumph-Adler DC 2023 - Manual (Page 114)

3A180100A
3A1/FaxSystem(A)/MCE-Eng
/ 164
H. Relay Broadcast Transmission
(Continued from step 5, page 4-35)
6. Use the cursor up or the cursor down key to select “Relay comnd
TX”.
7. Press the Enter key.
8. Use the cursor up or the cursor down key to select whether or not
you want to designate a time for the transmission to begin.
> If you want to designate a time for the transmission to begin,
select “On” and proceed to step 9.
> If you want to have the transmission begin immediately after the
program key is pressed, select “Off” and proceed to step 11.
9. Press the Enter key.
10. Use the keypad to enter the desired time for the transmission to
begin.
* If you want to reset the displayed time to “00:00”, simply press
the Stop/Clear key.
11. Press the Enter key.
12. Enter the fax number of a relay station.
13. Press the Enter key.
* If the fax number you entered has already been registered for
this operation, an error message will appear in the message
display. In this case, press the Enter key and the message
display will return to a display that allows you to enter the fax
number again.
* If you have entered too many fax numbers or relay stations,
an error message will appear in the message display. In this
case, press the Enter key and proceed to step 23 on page 4-43.
4-42
Section 4 Other Features of this Fax
14. Enter the destination party’s fax number.
* You can enter the fax number using the keypad, abbreviated
numbers, one-touch keys or the directory. Chain dial keys can
be used as well.
15. Press the Enter key.
* If there is some problem with the information that you entered,
an error message will appear and then the message display will
return to a display that allows you to enter the destination
party’s fax number again.
16. Enter a name for the program.
* The program name can be up to 20 characters in length.
(Refer to “Entering characters”, page 1-28.)
17. Press the Enter key. The entered information will become
registered under the designated program key.
> If you want to continue registering other program keys,
return to step 4, page 4-35.
> If you are finished registering program keys, press the Reset
key. The operation panel will return to the initial mode settings.
v :486293
Enter fax number
DCES
Enter program name
Enter program name
Program:05:Select mode
Confi. polling RX
Confidential TX
➪ Relay comnd TX
Delayed comm.:
➪
On
Off
TX time:17:00
Enter transmission time
v :
Enter relay station
Print at relay station:
➪
On
Off
v :33865
Enter relay station
04/OtherF-3/3A1/MCE/Eng.q 23-12-1999 14:02 Page 4-42