TA Triumph-Adler DC 2023 - Manual (Page 11)

1-3
Section 1 Basic Use of this Fax
(2) Operation Panel Parts and their Functions
The following contains explanations on the names and functions of the keys and indicators
that are utilized when this machine is used as a facsimile. Refer to the Instruction
Handbook for your copier for information on the keys and indicators that are utilized when
this machine is used as a copier.
3A180100A
3A1/FaxSystem(A)/MCE-Eng
/ 164
1 Message display…Operation procedures and indications of
trouble, etc., are shown in the message display.
2 Cursor left key…Press this key when you want to move the
cursor in the message display to the left.
3 Cursor right key…Press this key when you want to move the
cursor in the message display to the right.
4 Cursor down key…Press this key when you want to move the
cursor downward in the message display.
5 Cursor up key…Press this key when you want to move the
cursor upward in the message display.
6 Enter ( ) key…Press this key when you want to advance to the
next step in an operation or when you want to register the entered
data during setting and registration procedures.
7 Interrupt key…Press this key when you want to interrupt a fax
reception in order to make copies. The lamp in the Interrupt key
will light when the machine is in the Interrupt mode.
8 Keypad…Use the keypad to enter fax numbers, etc.
9 Reset key…Press this key when you want to cancel an operation
in progress and have the operation panel return to the initial
mode settings.
0 Stop/Clear key…Press this key when you want to revise data
that you have entered and return the message display to the
previous step. (The message display will NOT, however, return to
the previous step if the Enter key has already been pressed in
order to register that data.) Press this key also during registration,
modification or deletion procedures when you want to delete the
data that is currently displayed.
! Start key…Press this key when you want to initiate fax
transmission and manual fax reception.
@ FAX key…Press this key when you want to switch from the Copy
Operation mode to the Fax Operation mode. The lamp in this key
is lit when the machine is in the Fax Operation mode.
# COPY key…Press this key when you want to switch from the Fax
Operation mode to the Copy Operation mode. The lamp in this
key is lit when the machine is in the Copy Operation mode.
01/Basic-1/3A1/MCE/Eng.q 23-12-1999 13:08 Page 1-3