TA Triumph-Adler DC 2023 - Manual (Page 161)

Section 8 Reference Information
8-11
3A180100A
3A1/FaxSystem(A)/MCE-Eng
/ 164
U09000
Communication was attempted but, but was unsuccessful because the other party’s fax does not match the communication
protocol in use (the other party is using a G2 facsimile).
U12000
A relay command was received, but the data to be transmitted was not completely received because your memory has
become full. Clear your memory of all other data and try again or abandon the Relay Broadcasting attempt.
CODE CAUSE AND/OR PROCEDURE FOR CORRECTION
U12100
The relay command was sent, but was unsuccessful because the relay station’s memory has become full.
Check with the relay station.
U14000
A reception from a Confidential Box or an F-Code box was attempted, but was unsuccessful because the memory in your
fax machine has become full. Print out data from memory and try again or abandon the Confidential Reception (or F-Code
Based Confidential Reception) attempt.
U14100
An error has occured due to one of the following reasons. Check with the other party.
1 A transmission to a destination party’s Confidential Box was attempted, but was unsuccessful because memory in the
destination party’s fax machine has become full.
2 The destination fax is one of our models and a transmission to a destination party’s F-Code Box was attempted,
but was unsuccessful because memory in the destination party’s fax machine has become full.
U19000
Memory Reception was attempted, but was unsuccessful because your memory has become full.
Clear your memory of all other data and attempt reception again.
U19100
Transmission was attempted, but was unsuccessful because the destination party’s memory has become full.
Check with the destination party.
U19200 The data stored in memory is faulty. Perform the necessary communication procedures again.
U19300
A transmission was attempted, but was unsuccessful because the data to be transmitted is faulty.
Perform the transmission procedure again.
U19400 A reception was attempted, but was unsuccessful because the received data is faulty. Perform the reception procedure again.
08/Reference/3A1/MCE/Eng.q 23-12-1999 14:39 Page 8-11