TA Triumph-Adler DC 2023 - Manual (Page 54)

2-6
Section 2 Various Functions of this Fax
* The fax is currently occupied with a communication in the
background.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
1. Raise both cover plates and press the MEMORY TX. key.
* Make sure the MEMORY TX. indicator is out (the fax is in the
Direct Feed Transmission mode).
3A180100A
3A1/FaxSystem(A)/MCE-Eng
/ 164
Interrupt Transmission
Interrupt Transmission lets you send your documents before
others, eliminating the need to wait until all communications are
complete whenever the fax is currently scheduled for multiple
communications (Broadcast Transmission or Polling Reception,
etc.), or there are other communications already scheduled in
memory ahead of yours. * Interrupt Transmission may only be accomplished to a single
destination.
* You can schedule up to 50 Interrupt Transmissions (including
communications that use the timer and Interrupt Transmissions)
at one time.
* Depending on the timing of when you perform the Interrupt
Transmission procedure, there are occasions where your
documents may not be send immediately after the current
communication.
* If you want to cancel an Interrupt Transmission, simply remove
the documents from the SRDF or the platen.
* If you press the Stop/Clear key while an Interrupt Transmission
is waiting to start, perform the same procedure as in “ ● If you
press the Stop/Clear key during a Standby Transmission in the
Direct Feed Transmission mode…”, page 2-3.
2. Set the documents you want to transmit in the SRDF or on the
platen.
* When the documents are set on the platen, it is necessary, after
each page is scanned, to select whether or not you want to
transmit more pages and to select the size of each page.
(Refer to page 1-23.)
3. Enter the destination fax number.
4. Press the Start key. The documents will remain in the SRDF or on
the platen, without being scanned, waiting for the transmitting
operation to begin.
Once the operation currently in progress is completed,
the transmission operation for your documents will begin
automatically.
01-DEC-1999 12:00
Set original
01-DEC-1999 12:00
Document :A4
Enter destination
v :3323
Document :A4
Press START-key
02/VariousF/3A1/MCE/Eng.q 23-12-1999 13:31 Page 2-6