TA Triumph-Adler DC 2023 - Manual (Page 112)

4-40
Section 4 Other Features of this Fax
E. Confidential Polling Reception
(Continued from step 5, page 4-35)
6. Use the cursor up or the cursor down key to select “Confi. polling RX”.
7. Press the Enter key.
8. Use the cursor up or the cursor down key to select whether or not
you want to designate a time for the reception to begin.
> If you want to designate a time for the reception to begin,
select “On” and proceed to step 9.
> If you want to have the reception begin immediately after the
program key is pressed, select “Off” and proceed to step 11.
9. Press the Enter key.
10. Use the keypad to enter the desired time for the reception to
begin.
* If you want to reset the displayed time to “00:00”, simply press
the Stop/Clear key.
11. Press the Enter key.
12. Enter the transmitting party’s Confidential Box number.
* The box number is a 4-digit number from “0000” to “9999”.
* If you want to reset the displayed number to “0000”,
simply press the Stop/Clear key.
13. Press the Enter key.
3A180100A
3A1/FaxSystem(A)/MCE-Eng
/ 164
Program:05:Select mode
Cont. polling RX
Reverse polling
➪ Confi. polling RX
Delayed comm.:
➪ On
Off
TX time:17:00
Enter transmission time
14. Enter the transmitting party’s Confidential Box ID.
* The box ID is a 4-digit number from “0000” to “9999”.
* If you want to reset the displayed number to “0000”,
simply press the Stop/Clear key.
15. Press the Enter key.
16. Enter the transmitting party’s fax number.
* You can enter the fax number using the keypad, abbreviated
numbers, one-touch keys or the directory. Chain dial keys can
be used as well.
17. Press the Enter key.
* If there is some problem with the information that you entered,
an error message will appear and then the message display will
return to a display that allows you to enter the transmitting
party’s fax number again.
18. Enter a name for the program.
* The program name can be up to 20 characters in length.
(Refer to “Entering characters”, page 1-28.)
19. Press the Enter key. The entered information will become
registered under the designated program key.
> If you want to continue registering other program keys,
return to step 4, page 4-35.
> If you are finished registering program keys, press the Reset
key. The operation panel will return to the initial mode settings.
Box ID:9450
Enter box ID
Box nr:0549
Enter box nr
Box nr:0000
Enter box nr
Box ID:0000
Enter box ID
v :
Enter fax number
CONF-S
Enter program name
04/OtherF-3/3A1/MCE/Eng.q 23-12-1999 14:02 Page 4-40