TA Triumph-Adler DC 2023 - Manual (Page 138)

* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
1. Press the CONFIGURE key.
2. Use the cursor up or the cursor down key to select “Print report”.
6-2
Turning Report Print Out ON/OFF
Five different reports can be printed out for checking such points as
whether a transmission or reception was accomplished correctly or
not. You can also have each of these reports printed out
automatically or turn OFF automatic print out of each report.
3. Press the Enter key.
4. Use the cursor up or the cursor down key to select which report to set.
* The following example is for setting the Delayed Communication
Report.
5. Press the Enter key.
6. Use the cursor up or the cursor down key to select whether or not
you want that report to be automatically printed out.
* The asterisk (*) in the message display indicates the current
setting.
* If you want the report to be printed out automatically, select “On”.
7. Press the Enter key. The setting for that report is complete.
> If you want to continue the setting procedure for other reports,
repeat steps 4 - 7.
> If you want to perform other setting procedures, select “End” and
then press the Enter key.
> If you are finished making settings, press the Reset key.
The operation panel will return to the initial mode settings.
Section 6 Various Settings and Registration in this Fax
3A180100A
3A1/FaxSystem(A)/MCE-Eng
/ 164
Print report:
TX transaction:On
RX transaction:Off
➪ Delayed comm. :On
Delayed comm. report:
➪ *On
Off
Delayed comm. report:
*On
➪ Off
Print report:
TX transaction:On
RX transaction:Off
➪ Delayed comm. :Off
Print report:
End
➪ Activity contr:On
Management :On
Set fax:
End
TTI :Outside p.
➪
Print report
P
Set this report to be printed out upon reaching a predetermined
number of communications in order to check the details of those
communications.
Set this report to be printed out in order to check the details,
listed by id-code, of all communications occurring under
Restricted Access.
Set this report to be printed out after each transmission to check
whether the transmission was accomplished correctly or not.
Set this report to be printed out after each reception to check
whether the reception was accomplished correctly or not.
Set this report to be printed out after each communication that
uses the timer is scheduled to check the information related to
that communication.
01-DEC-1999 12:00
Set original
Set fax:
End
➪
TTI :Outside p.
Print report
P
06/Setting/3A1/MCE/Eng.q 23-12-1999 14:28 Page 6-2