TA Triumph-Adler DC 2023 - Manual (Page 66)

3-2
Section 3 Troubleshooting
When the MEMORY Indicator is Lit…
During a fax communication that uses the memory, documents will
be entered into memory and, to indicate this, the MEMORY indicator
will light. The MEMORY indicator will also light when documents are
received directly into memory (Memory Reception) because paper
has run out or a paper jam has occurred.
* The MEMORY indicator will flash while documents are being
scanned or are being received into memory.
(1) CAUTIONS before Disconnecting the Power
• As electricity is necessary to retain documents in memory,
BE SURE to check whether the MEMORY indicator is lit or not
BEFORE intentionally disconnecting power to this machine. If there
are documents in memory and the indicator IS lit, print out all
important documents from memory and then make sure that the
MEMORY indicator is out BEFORE disconnecting the power.
* The Imaging Memory back-up function of this machine will protect
the contents of memory for up to 30 minutes (4 MB of optional
Imaging Memory must be installed) even if, for any reason, power
to the fax is disconnected or lost. However, depending on certain
conditions in this machine, a portion of the first data received may
be lost. Ask the other party to retransmit any documents for which
data was lost.
• NEVER disconnect the power to this machine while the sound of
the internal motor can be heard. If power is disconnected while the
motor is running, there is a danger of damaging or contaminating
the inside of the machine.
(2) If a Power Failure Report is Printed Out…
If documents or other information contained in memory are lost
because power to the fax is disconnected or lost, a Power Failure
Report will be printed out once power is restored.
Refer to this report to find out what information was lost.
* If no data or information was lost, a Power Failure Report will not
be printed out.
When the ERROR Indicator is Lit
(and the Alarm Buzzer Sounds)…
In the event of trouble, the alarm will sound and the ERROR
indicator will first flash and will then light continuously. Refer to the
message display for an explanation in regard to the error and follow
the necessary procedure to eliminate the trouble.
(Refer to “When One of These Message is Displayed…”, page 3-3,
and “Troubleshooting Tables”, page 3-5.)
* Press the Reset key to make the ERROR indicator go out.
3A180100A
3A1/FaxSystem(A)/MCE-Eng
/ 164
03/Trouble/3A1/MCE/Eng.q 23-12-1999 13:44 Page 3-2