TA Triumph-Adler DC 2023 - Manual (Page 28)

3A180100A
3A1/FaxSystem(A)/MCE-Eng
/ 164
1-20
Section 1 Basic Use of this Fax
Setting the documents
1 Adjust the original insert guides to match the width of the
documents you want to transmit.
2 Open the eject guide when transmitting documents of a
large size such as B4 or A3.
● Acceptable documents
> When set in the SRDF…
• Type: Plain paper, coloured paper, recycled paper
• Size: A5R - A3, Folio
(Width: 148 mm - 297 mm, Length: 148 mm - 1700 mm)
* If you attempt to transmit a document over 1700 mm in length,
a message indicating that a document jam has occurred in the
SRDF will appear in the message display.
• Paper weight… 1-sided documents: 35 g/m 2 - 160 g/m 2
Duplex (2-sided) documents: 50 g/m 2 - 120 g/m 2
• Number (plain paper):
Under A4: 70 sheets
B4 or A3: 50 sheets
> When set on the platen…
• Maximum size: A3
● Notes on acceptable documents
• If documents with very low contrast images or light coloured text
are transmitted, they may not be received clearly by the other party.
• MAKE SURE that documents written in ink or containing glue, etc.,
have dried COMPLETELY before setting them for transmission.
• When setting documents in the SRDF, ALWAYS set documents
AFTER removing any clips and staples as they can cause damage
to the machine.
• Documents of sizes outside the prescribed range may not be
transmitted successfully.
• If documents with punch holes are set in the SRDF for transmission,
grey streaks may appear on the documents received by the other
party. In this case, set the documents in a different direction and try
to transmit them again.
33
3 Set the documents face-up on the original table.
* If the documents are set properly, the original set indicator
will be lit green. If the indicator is flashing green,
the documents are not set properly. If the indicator is flashing
red, a paper jam has occurred.
* DO NOT set more documents than indicated by the paper
volume lines that are located on the inside of the rear original
insert guide. Setting more than the acceptable number of
documents can be the cause of document jams.
* Refer to the Instruction Handbook for your SRDF for more
detailed information regarding use of the SRDF.
* It is possible to set duplex (2-sided) documents and have
both the front and back sides of those documents
transmitted. (Refer to “Duplex Transmission”, page 2-2.)
Documents can also be transmitted by lifting open the SRDF
and setting one document at a time directly on the platen.
ALWAYS use the platen when transmitting pages from books
and the like.
1 Set the document face-down and align it properly with the
lines on the original size scales.
2 When transmitting single-sheet documents directly from the
platen, BE SURE to close the SRDF.
CAUTION
DO NOT leave the document feeder open as there is
a danger of personal injury.
01/Basic-1/3A1/MCE/Eng.q 23-12-1999 13:08 Page 1-20