TA Triumph-Adler DC 2023 - Manual (Page 145)

6-9
3. Press the Enter key.
4. Use the cursor up or the cursor down key to select the desired
paper feed mode.
* The asterisk (*) in the message display indicates the current
setting.
> If you selected “Auto selection”…
Proceed to step 5.
> If you selected “Fixed size”…
1 Press the Enter key.
2 Use the cursor up or the cursor down key to select the desired
paper size.
> If you selected “Fixed cassette”…
1 Press the Enter key.
2 Use the cursor up or the cursor down key to select the desired
drawer.
5. Press the Enter key.
The setting for Paper Feed Selection is complete.
* If you are finished making settings, press the Reset key.
The operation panel will return to the initial mode settings.
Section 6 Various Settings and Registration in this Fax
3A180100A
3A1/FaxSystem(A)/MCE-Eng
/ 164
Paper feed sel:
➪ *Auto selection
Fixed size P
Fixed cassette
P
Fixed cassette:
➪ Top drawer
2nd drawer
3rd drawer
Set fax:
Reception mode:Fax recept
RX date/time :Off
➪
Paper feed sel:2nd drawer
Fixed size:
➪ A3
B4
A4
Turning Remote Diagnosis ON/OFF
Especially if trouble occurs in this fax in which it is necessary to call
for service, it is possible for our service centre computer to access
the fax directly over the telephone line and check its status and other
information about the trouble.
* To use Remote Diagnosis, it is necessary to enter into a contract
with an authorized service centre in advance and also to register a
predetermined Remote Test ID in advance.
(Refer to “Registering the Remote test ID”.)
For further information, contact your service representative, an
authorized service centre or the place of purchase.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
1. Press the CONFIGURE key.
2. Use the cursor up or the cursor down key to select “Remote diagn.”.
3. Press the Enter key.
4. Use the cursor up or the cursor down key to select whether to turn
Remote Diagnosis ON or OFF.
* The asterisk (*) in the message display indicates the current
setting.
5. Press the Enter key. The setting for Remote Diagnosis is complete.
* If you are finished making settings, press the Reset key.
The operation panel will return to the initial mode settings.
Remote diagn.:
➪ On
*Off
Set fax:
2-up RX :Off
Management :Off
➪
Remote diagn. :Off
Set fax:
2-up RX :Off
Management :Off
➪
Remote diagn. :On
01-DEC-1999 12:00
Set original
Set fax:
End
➪ TTI :Outside p.
Print report
P
06/Setting/3A1/MCE/Eng.q 23-12-1999 14:29 Page 6-9