TA Triumph-Adler DC 2023 - Manual (Page 115)

3A180100A
3A1/FaxSystem(A)/MCE-Eng
/ 164
4-43
Section 4 Other Features of this Fax
14. Select whether or not you want the documents to be printed out
at the relay station.
* If you want the documents to be printed out, select “On”.
If you DO NOT want the documents to be printed out, select “Off”.
15. Press the Enter key.
16. Enter the fax number of a final destination.
Print at relay station:
On
➪ Off
v :
Enter destination station
If you want to use the abbreviated numbers or one-touch keys
registered in the relay station’s fax machine to enter the fax
number of a final destination, or of the party to send the
Transmission Report to…
● Abbreviated number…Press the pound key and then enter
the 2-digits (00 - 99) for the corresponding abbreviated
number.
* If the relay station’s fax machine is the same model as this
fax, an abbreviated number from 000 - 199 can be registered.
However for this procedure, numbers 100 - 199 are not
available.
● One-touch key…Press the star key and then enter the
2-digits that correspond to the desired one-touch key.
17. Press the Enter key.
* If the fax number you entered has already been registered for
this operation or too many numbers were entered, an error
message will appear in the message display. In this case,
press the Enter key and the message display will return to a
display that allows you to enter the fax number again.
18. Select whether or not you want to continue entering other
destination fax numbers.
> If you DO want to continue entering fax numbers, return to
step 16.
> If you are finished entering fax numbers, proceed to step 19.
v :
Enter destination station
19. Press the Enter key.
20. If you want to have a Transmission Report sent from this relay
station, enter your fax number as it would be entered by
someone at that station.
* This Transmission Report will show the results of the
transmissions from that relay station to each of the
corresponding final destinations. If you do not want to have this
report sent to you, this step is not necessary. Proceed to step 21.
* As it is necessary for the relay station to dial your fax number,
your number should be entered using an abbreviated number or
one-touch key registered in the relay station’s fax machine to
enter the number. (Refer to .)
21. Press the Enter key.
22. Select whether or not you want to continue registering relay
stations.
> If you DO want to continue registering other relay stations,
return to step 12 on page 4-42.
> If you are finished registering relay stations, proceed to step 23.
23. Press the Enter key.
24. Enter a name for the program.
* The program name can be up to 20 characters in length.
(Refer to “Entering characters”, page 1-28.)
25. Press the Enter key. The entered information will become
registered under the designated program key.
> If you want to continue registering other program keys,
return to step 4, page 4-35.
> If you are finished registering program keys, press the Reset
key. The operation panel will return to the initial mode settings.
TX destination report:
2 digits
Enter report destination
TX destination report:#28
2 digits
Enter report destination
v :
Enter relay station
RCKS
Enter program name
Enter program name
04/OtherF-3/3A1/MCE/Eng.q 23-12-1999 14:02 Page 4-43