Sending documents, Sending documents -18 – TA Triumph-Adler DC 2023 User Manual

Page 26

3A180100A

3A1/FaxSystem(A)/MCE-Eng

/ 164

1-18

Section 1 Basic Use of this Fax

Sending Documents

The following contains explanations on the standard method for transmitting
documents. Carefully read all the notes regarding acceptable documents, etc.,
to ensure correct operation.

Switching to the Fax Operation mode

Press the FAX key to switch to the Fax Operation mode.
* When the lamp in the FAX key is lit, the machine is in the

Fax Operation mode.

* Check the message display to make sure that the operation panel

is in the initial mode for fax operation. If the operation panel is not
in the initial mode, press the Reset key.

Selecting the transmission mode

Select the desired transmission mode.
* There are two transmission modes available in this fax:

Memory Transmission and Direct Feed Transmission.
Memory Transmission is the default setting in this fax and,
in this case, the MEMORY TX. indicator will be lit.

* To switch between the Memory Transmission and Direct Feed

Transmission modes, raise both cover plates and press the
MEMORY TX. key.

* If the MEMORY TX. indicator is NOT lit, the fax is in the

Direct Feed Transmission mode.

01-DEC-1999 12:00

Set original

01/Basic-1/3A1/MCE/Eng.q 23-12-1999 13:08 Page 1-18

This manual is related to the following products:

DC 2031