TA Triumph-Adler DC 2023 - Manual (Page 53)

2-5
Section 2 Various Functions of this Fax
4. If you want to designate the communication for this fax number as
an F-Code Based Communication, press the SUBADDRESS key.
> If you pressed the SUBADDRESS key, proceed to step 5.
> If you DID NOT press the SUBADDRESS key, proceed to step 8.
5. Enter the subaddress you want to use for this F-Code Based
Communication.
* The subaddress can be up to 20 digits in length and can include
any combination of the numerals 0 - 9.
6. Press the Enter key.
7. If necessary, enter the predetermined F-Code password.
* The password can be up to 20 digits in length and can include
any combination of the numerals 0 - 9 and the symbols “ ” and
“#”. You do not have to enter an F-Code password here if you
agree in advance with the destination party not to use one.
* If you DO NOT need to enter an F-Code password, proceed to
step 8.
8. Press the Enter key.
* If the fax number you entered has already been registered for
this operation or too many numbers were entered, an error
message will appear in the message display. In this case,
press the Enter key and the message display will return to a
display that allows you to enter the destination fax number again.
9. Select whether or not you want to continue entering other
destination fax numbers.
> If you DO want to enter more fax numbers, return to step 3 on
page 2-4.
> If you are finished entering fax numbers, proceed to step 10.
3A180100A
3A1/FaxSystem(A)/MCE-Eng
/ 164
10. If you want to designate a time for the transmission to begin,
press the DELAYED TX. key.
* If the maximum allowable number of communications that use
the timer (max: 50) is reached, an error message will appear in
the message display. In this case, press the Enter key and the
operation panel will return to the initial mode settings.
* If you want the transmission to begin right away, this step is not
necessary. Proceed to step 13.
11. Press the Enter key.
12. Use the keypad to enter the desired time for the transmission to
begin.
* If you want to reset the displayed time to “00:00”, simply press
the Stop/Clear key.
13. Press the Enter key. The documents will be scanned into
memory and the transmission operation will begin automatically.
* If a time for the transmission to begin was designated,
the transmission operation will begin when the appointed time is
reached.
Subaddress:
66385
20 digits
Enter subaddress numbers
Password:
20 digits
Enter your password
Password:
38566
20 digits
Enter your password
TX time:20:00
Enter transmission time
v :
Document :A4
Enter destination
02/VariousF/3A1/MCE/Eng.q 23-12-1999 13:31 Page 2-5