TA Triumph-Adler DC 2023 - Manual (Page 76)

4-4
Section 4 Other Features of this Fax
(1) Changing the Remote Switching Number
The factory default setting for the Remote Switching Number is “55”,
but you can change this if you want.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
1. Raise both cover plates and press the REGISTER key.
2. Use the cursor up or the cursor down key to select “Program fax
parameter”.
3. Press the Enter key.
4. Use the cursor up or the cursor down key to select
“Remote switch”.
5. Press the Enter key.
6. Use the keypad to enter the new Remote Switching Number
(2 digits).
* If you want to reset the displayed number to “00”, simply press
the Stop/Clear key.
7. Press the Enter key.
Registration of the new Remote Switching Number is complete.
* Press the Reset key. The operation panel will return to the initial
mode settings.
3A180100A
3A1/FaxSystem(A)/MCE-Eng
/ 164
Remote Switching
Remote Switching lets you initiate fax reception from a
telephone that is connected to this fax machine. This function is
thus convenient if you want to be able to initiate fax reception
from a location separate from the fax machine itself. * Remote Switching is only possible if a separately purchased
telephone with tone dialling capabilities is connected to this fax
machine.
Program:
End
➪
Program abbreviated dial
Program one-touch key
Program:
Subaddress box register
Program encryption code
➪
Program fax parameter
P
Program fax parameter:
End
➪ v :
Own name :
Program fax parameter:
Permit number P
Fax forwarding
P
➪ Remote switch :55
Remote switch:55
Enter remote switching number
Remote switch:11
Enter remote switching number
(2) Operation
When you want to initiate fax reception from a telephone that is
connected to this fax machine, perform the following procedure.
1. When a call comes in, the telephone will ring.
2. Pick up the telephone receiver.
3. If you hear a fax tone, use the tone signal capabilities of the
telephone to enter the 2-digit Remote Switching Number.
* The factory default setting for the Remote Switching Number is
“55”.
4. The connection will switch to the fax machine and fax reception
will start automatically.
04/OtherF-1/3A1/MCE/Eng.q 23-12-1999 13:48 Page 4-4