TA Triumph-Adler DC 2023 - Manual (Page 68)

3A180100A
3A1/FaxSystem(A)/MCE-Eng
/ 164
3-4
Section 3 Troubleshooting
Message Procedure Page
“Communication error”
An error has occurred during a fax transmission or fax reception.
Check the error code – that indicates the origin of the error – on the corresponding
Transmission Report (or Reception Report) that is printed out after the error.
8-8
“Continue transmission”
This message will appear in response to pressing the Stop/Clear key while the
ALTERNATE DISPLAY key is held down during a communication to multiple
destinations, such as Broadcast Transmission or Polling Reception.
• Use the cursor up or the cursor down key to select “Yes” if you want to continue the
current operation. However, the individual communication in progress at the time the
Stop/Clear key was pressed will be cancelled.
• Use the cursor up or the cursor down key to select “No” if you want to cancel the
communication to all remaining destinations.
* During Continuous Polling Reception, only the polling cycle in progress at the time
the Stop/Clear key was pressed will be cancelled and all subsequent polling cycles
will be accomplished on schedule.
___
“CALL FOR SERVICE.”
Maintenance by qualified service personnel is required. Contact your service
representative, an authorized service centre or the place of purchase.
If “C” and a 3-digit number are displayed as well, inform the service personnel of the
displayed number.
___
“Time for maintenance”
Maintenance by qualified service personnel is required. Contact your service
representative, an authorized service centre or the place of purchase. ___
“MISFEED IN FEEDER.
REMOVE ORIGINAL(S).” ___
2-14
4-16
4-22
A document has jammed in the SRDF. Refer to the included Instruction Handbook for
your SRDF and remove the jammed document.
Then, reset all of the documents in the SRDF. The fax will recount the number of
documents that were already scanned and will start the scanning operation once again
from the document that jammed.
The memory has reached its capacity while scanning in documents. Press the Enter
key and perform the appropriate procedure according to the contents of the message
display.
If you do not press the Enter key within a certain amount of time, the Auto Clear
function will engage and all corresponding data will be erased from memory.
“Memory full”
03/Trouble/3A1/MCE/Eng.q 23-12-1999 13:44 Page 3-4