Yaskawa Matrix Converter - Manual (Page 77)

Operation Modes
3-
9
‹ Quick Programming Mode
In the Quick Programming Mode, the user can set the basic parameters required to test run the MxC.
Parameters can be changed from the setting display screen. Use the up arrow, down arrow, and right arrow
keys to change parameter settings. Any changes will be saved once the DATA/ENTER key is pushed.
Refer to Chapter 5 MxC Parameters for details on the parameters displayed in Quick Programming Mode.
„ Making Changes in the Quick Programming Mode
Key operations in Quick Programming Mode are shown in the following figure.
Fig 3.5 Operations in Quick Programming Mode
** Main Menu **
-DRIVE-
Operation
** Main Menu **
-QUICK-
Quick Setting
** Main Menu **
-ADV-
Programming
** Main Menu **
-VERIFY-
Modified Consts
** Main Menu **
-A.TUNE-
Auto-Tuning
MENU
Control Method
-QUICK-
A1-02=2 *2*
Open Loop Vector
Reference Source
-QUICK-
b1-01=1 *1*
Terminals
MENU
MENU
MENU
MENU
ESC
DATA
ENTER DATA
ENTER
ESC
Run Source
-QUICK-
b1-02=1 *1*
Terminals
Monitor display Setting display Mode selection display
MOL Fault Select
-QUICK-
L1-01=1 *1*
Std Fan Cooled
Terminal AM Gain
-QUICK-
(0.00 ←→2.50)
̍0.50̍
H4-05=0.50
A B
A B
Control Method
-QUICK-
A1-02= 2 *2*
Open Loop Vector
Reference Source
-QUICK-
b1-01= 1 *1*
Terminals
DATA
ENTER
ESC
Run Source
-QUICK-
b1-02= 1 *1*
Terminals
DATA
ENTER
ESC
Terminal AM Gain
-QUICK-
(0.00 㨪2.50)
̍0.50̍
H4-05= 0 .50
MOL Fault Select
-QUICK-
L1-01= 1 *1*
Std Fan Cooled
DATA
ENTER
ESC
DATA
ENTER
ESC