Yaskawa Matrix Converter - Manual (Page 305)

6
-140
„ Setting Output Items for the DO-08 Digital Output Card
If using DO-08 Digital Output Card, select one of the following three output modes according to the setting in
F5-09.
F5-09 Set to 0
F5-09 Set to 1
The following table shows the code outputs.
F5-09 Set to 2
Output depends on the settings in F5-01 to F5-08.
Set Value
Terminal
Number
Output Details
0: 8 separate
outputs
TD5-TD11 Overcurrent (OC, GF)
TD6-TD11 Overvoltage (OV, AOV)
TD7-TD11 MxC overload (OL2, OH2)
TD8-TD11 Not used
TD9-TD11 Overspeed (OS)
TD10-TD11 MxC overheated (OH1) or motor overload (OL1)
TD1-TD2 Zero-speed detected
TD3-TD4 Speed Agree
Set Value
Terminal
Number
Output Details
1: Binary code
output
TD5-TD11 bit 0
Encoded output
(Refer to table below) TD6-TD11 bit 1
TD7-TD11 bit 2
TD8-TD11 bit 3
TD9-TD11 Zero-speed detected
TD10-TD11 Speed Agree
TD1-TD2 Operating
TD3-TD4 Minor fault
Bits 3, 2, 1,
and 0
Output Details
Bits 3, 2, 1,
and 0
Output Details
0000 No error 1000 External fault (EF †† )
0001 Overcurrent (OC, GF) 1001 Controller error (CPF †† )
0010 Overvoltage (OV, AOV) 1010 Motor overload (OL1)
0011 MxC overload (OL2, OH2) 1011 Not used
0100 MxC overheated (OH, OH1) 1100 Power loss (UV1, UV2, FDV, AUV, or SRC)
0101 Overspeed (OS) 1101 Speed deviation (DEV)
0110 Not used 1110 PG Disconnect (PGO)
0111 Built-in resistor overheated (SOH, DOH) 1111 Not used