Yaskawa Matrix Converter - Manual (Page 244)

Monitor Parameters
6-
79
Monitor Parameters
This section explains the analog monitor and pulse monitor parameters.
‹ Using the Analog Monitor Parameters
This section explains the analog monitor parameters.
„ Related Parameters
Parameter
Number
Name
Description
Setting
Range
Default
Change
during
Run
Control Methods
Display V/f
Open
Loop
Vector
Flux
Vector
H4-01
Terminal FM
Monitor Selection Sets the number of the monitor item to be out-
put (U1-††) from terminal FM.
Items that can be set differ in accordance with
the selected control modes.
For information on the parameters for which
analog output is possible, refer to U: Monitors.
1 to 99 2 No A A A
Terminal FM Sel
H4-02
Terminal FM
Gain Setting Sets the multi-function analog output 1 volt-
age level gain.
Sets whether the monitor item output will be
output in multiples of 10 V.
The maximum output from the terminal is 10
V.
A meter calibration function is available.
*
0.00 to
2.50
1.00 Yes Q Q Q
Terminal FM
Gain
H4-03
Terminal FM Bias
Setting Sets the multi-function analog output 1 volt-
age level bias.
Sets output characteristic up/down parallel
movement as a percentage of 10 V.
The maximum output from the terminal is 10
V.
A meter calibration function is available.
*
-10.0 to
+10.0
0.0% Yes A A A
Terminal FM Bias
H4-04
Terminal AM
Monitor Selection Sets the number of the monitor item to be out-
put (U1-††) from terminal AM.
Items that can be set differ in accordance with
the selected control modes.
For information on the parameters for which
analog output is possible, refer to U: Monitors.
1 to 99 3 No A A A
Terminal AM Sel
H4-05
Terminal AM
Gain Setting Set the voltage level gain for multi-function
analog output 2.
Set the number of multiples of 10 V to be out-
put as the 100% output for the monitor items.
The maximum output from the terminal is 10
V.
A meter calibration function is available.
*
0.00 to
2.50
0.50 Yes Q Q Q
Terminal AM
Gain
H4-06
Terminal AM
Bias Setting Sets the multi-function analog output 2 volt-
age level bias.
Sets output characteristic up/down parallel
movement as a percentage of 10 V.
The maximum output from the terminal is 10
V.
A meter calibration function is available.
*
-10.0 to
+10.0
0.0% Yes A A A
Terminal AM
Bias
H4-07
Terminal FM Sig-
nal Level Selec-
tion Sets the signal output level for multi-function
output 1 (terminal FM)
0: -10 to 10 VDC output
1: -10 to 10 VDC output
0 or 1 0 No A A A
AO Level Select 1
* If the setting display of H4-02 or H4-03 appear when the motor is not rotating in the Quick, Advanced, or Verify Mode, the FM output can be adjusted.
If the setting display of H4-05 or H4-06 appear when the motor is not rotating in the Quick, Advanced, or Verify Mode, the AM output can be adjusted.
For analog output, multiple gain 100% of the output the items that can be monitored.