Yaskawa Matrix Converter - Manual (Page 34)

Removing/Attaching the Digital Operator and Front Cover
1-
15
„ Attaching the Front Cover
After completing required work (i.e., installing an option card, setting the control circuit terminal board, etc.),
attach the front cover by reversing the procedure to remove it.
1. Make sure that the digital operator is not mounted on the front cover. Contact faults can occur if the cover
is attached while the digital operator is still connected.
2. Insert the tab on the top of the front cover into the slot on the MxC and press in on the cover until it clicks
into place on the MxC.
„ Attaching the Digital Operator
After attaching the front cover, plug the digital operator key pad into the front of the unit as follows:
1. Hook the digital operator at point A (two locations) on the front cover in the direction of arrow 1 as shown
in the illustration below.
2. Press the digital operator in the direction of arrow 2 until it snaps in place at B (two locations).
Fig 1.16 Mounting the Digital Operator (Model: CIMR-ACA4011)
A
B