Yaskawa Matrix Converter - Manual (Page 70)

3
-2
Digital Operator
This section describes the displays and functions of the digital operator.
‹ Overview of the Digital Operator
The digital operator key names and functions are described below.
Fig 3.1 Digital Operator Component Names and Functions
‹ Digital Operator Keys
The names and functions of the digital operator keys are described in Table 3.1.
Note: Except in diagrams, keys are referred to by the key names listed in the following table.
Table 3.1 Key Functions
Key Name Function
LOCAL/REMOTE key
Switches between operation via the digital operator (LOCAL) and
control circuit terminal operation (REMOTE).
This key can be enabled or disabled by setting parameter o2-01.
MENU key
Scrolls through the five main menus:
Operation (-DRIVE-), Quick Setting (-QUICK-), Programming
(-ADV-), Modified Parameters (-VERIFY-), and Auto-Tuning
(-A.TUNE-).
ESC key
Returns to the current screen to the previous screen display before the
DATA/ENTER key was pressed.
JOG key
Enables jog operation when the MxC is being operated from the digi-
tal operator.
Drive Mode Indicators
FWD: Lit when there is a Forward Run Command input.
REV: Lit when there is a Reverse Run Command input.
SEQ: Lit when the Run Command from the control
circuit terminal is enabled.
REF: Lit when the frequency reference from control
circuit terminals A1 and A2 is enabled.
ALARM: Lit when an error or alarm has occurred.
Data Display
Displays monitor data, parameter numbers, and settings.
Mode Display (Displayed at upper left of data display.)
DRIVE: Lit in Drive Mode.
QUICK: Lit in Quick Programming Mode.
ADV: Lit in Advanced Programming Mode.
VERIFY: Lit in Verify Mode.
A. TUNE: Lit in Auto-Tuning Mode.
Keys
Execute operations such as setting parameters,
monitoring, jogging, and Auto-Tuning.
Frequency Ref