HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 91)

HEIDENHAIN MANUALplus 620, CNC PILOT 640 91
2.5 Units—Dr
illing in C axis
"Linear tapping pattern, face" unit
The unit machines a linear tapping pattern in which the individual
features are arranged at a regular spacing on the face.
Unit name: G73_Lin_Stirn_C / Cycle: G73 (see page 328)
Use the retraction length for floating tap holders. The cycle
calculates a new nominal pitch on the basis of the thread depth, the
programmed pitch, and the retraction length. The nominal pitch is
somewhat smaller than the pitch of the tap. During tapping, the tap is
pulled away from the chuck by the retraction length. With this method
you can achieve higher service life from taps.
Access to the technology database:
 Machining operation: Tapping
 Affected parameters: S
Pattern form
Q
Number of holes
X1, C1 Polar starting point
XK, YK Cartesian starting point
I, J End point (XK, YK)
Ii, Ji: Distance (XKi, YKi)
R Distance to first/last hole
Ri Incremental distance
A Pattern angle (reference is XK axis)
Cycle form
Z1
Start point drill (starting point of hole)
Z2 End point drill (end point of hole)
F1 Thread pitch
B Run-in length
L Retraction length when using floating tap holders (default: 0)
SR Retraction speed (default: Shaft speed for tapping)
SP Chip breaking depth
SI Retraction distance
RB Retraction plane (default: return to the starting position or
to the safety clearance)
Further forms: see page 60