HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 50)

50 NC programming
1
.3 Pr
ogr
a
m section code
TURRET section
The TURRET program section defines the assignment of the tool
carrier. For every assigned turret pocket, the tool ID number is
entered. For multipoint tools, every cutting edge is entered in the
turret list.
BLANK section
In this program section, you describe the contour of the workpiece
blank.
AUXIL_BLANK section
In the AUXIL_ BLANK section, you define additional workpiece blanks,
which can be activated with G702 when required.
FINISHED section
In this program section, you describe the contour of the finished part.
After the FINISHED section you use additional section codes such as
FACE_C, LATERAL_C, etc.
AUXIL_CONTOUR section
In this program section, you describe the auxiliary turning contours.
Beispiel: Turret table
. . .
TURRET
T1 ID"342-300.1"
T2 ID"C44003"
. . .
 If you do not program the TURRET, the tools entered
in the tool list of the Machine operating mode will be
used.