HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 448)

448 DIN Programming
4.38 F
u
ll-surf
ace mac
h
ining
Full-surface machining with opposing spindle
G30: The expert program switches the kinematics of the
counterspindle. In addition, G30 activates the mirroring of the Z axis
and converts other functions (e.g. circular arcs G2, G3).
G99: The expert program shifts the contour and mirrors the coordinate
system (Z axis). Further programming of G99 is normally not required
for machining the rear face after rechucking.
Example: The workpiece is machined on the front face, transferred to
the opposing spindle through an expert program and machined on the
rear face (see illustrations).
The expert program is used for:
 Angle-synchronous workpiece transfer to the opposing spindle
 Mirroring traverse paths in the Z axis
 Activating a conversion list
 Mirroring the contour description and shifting for the 2nd setup
Full-surface machining on machines with opposing spindles
HEADER
#MATERIAL STEEL
#MEASURE_UNITS METRIC
TURRET
T1 ID "512-600.10"
T2 ID "111-80-080.1"
T102 ID "115-80-080.1"
BLANK
N1 G20 X100 Z100 K1
FINISHED
. . .
FACE_C Z0
N 13 G308 ID"Line" P-1
N 14 G100 XK-15 YK10
N 15 G101 XK-10 YK12 BR2
N 16 G101 XK-4.0725 YK-12.6555 BR4
N 18 G101 XK10
N 19 G309
REAR_C Z-98
. . .
MACHINING