HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 42)

42 NC programming
1
.2 The smar
t.T
u
rn
edit
or
"Goto" pull-down menu
The "Goto" pull-down menu contains the following jump and search
functions:
 Jump targets—The editor positions the cursor to the selected jump
target:
 To beginning
 To tool table
 To finished part
 To machining
 To end
 Search functions
 Find block number: You specify a certain block number. The
editor jumps to this block number if it exists.
 Find unit: The editor opens the list of units available in the
program. Select the desired unit.
 Find NC word: The editor opens the dialog for entering the
desired NC word. You can use the soft keys to search forward or
backward.
 Search for contour: The editor opens the list of contours
available in the program. Select the desired contour.
"Configuration" pull-down menu
The "Config" pull-down menu (Configuration) contains the following
functions:
 Input mode ...: Define the input mode
 ... NC editor (word-by-word): The editor works in the NC mode
(word by word)
 ... Text editor (character): The editor works character by
character (no syntax checking)
 Settings ...
 ... Save: The editor memorizes the open NC programs and the
respective cursor positions.
 ... Load last saved setting: Restores the last saved condition of
the editor.
 Technology data: Starts the technology editor