HEIDENHAIN SW 54843x-03 DIN Programming - Manual (Page 515)

HEIDENHAIN MANUALplus 620, CNC PILOT 640 515
6.3 Cont
ours in the YZ plane
Hole in YZ plane G380-Geo
G380 defines a single hole with countersinking and thread in the YZ
plane.
Linear slot in YZ plane G381-Geo
G381 defines the contour of a linear slot in the YZ plane.
Parameters
Y
Center of hole
Z Center of hole
B Hole diameter
P Depth of hole (excluding point)
W Point angle (default: 180°)
R Sinking diameter
U Sinking depth
E Sinking angle
I Thread diameter
J Thread depth
K Start of thread (runout length)
F Thread pitch
V Left-hand or right-hand thread (default: 0)
 0: Right-hand thread
 1: Left-hand thread
A Angle to X axis (range: –90° < A < 90°)
O Centering diameter
Parameters
Y
Center of slot
Z Center of slot
X Reference diameter
 No input: "X" from section code
 "X" overwrites "X" from section code
A Position angle (reference: positive Z axis; default: 0°)
K Slot length
B Slot width
P Pocket depth (default: "P" from G308)